widths
7 occurrences across the corpus
The Jerusalem Talmud
“It should be reduced.” How does one reduce? He makes a platform at the entrance of the alley and permits the alley. How much must it be? Rebbi Aḥa in the name of Rebbi Hoshaia: Four hand-breadths for an alley. Rebbi Yose says, one hand-breadth corresponding to the beam. The colleagues say, anything, since here is no longer a height of twenty cubits in the widths of a hand-breadth.
MISHNAH: From when the Ark was removed there was a stone there from the time of the earlier prophets; it was called Foundation, higher than the ground by three finger widths. On it he deposed it.
Rebbi Joḥanan said, the Ark was made with a cubit of six hand-breadths. Who stated “a cubit of six hand-breadths“? This is Rebbi Meןr’s. [As we have stated: “Rebbi Meןr says, all cubits were of buildings; Rebbi Jehudah says, the cubit of buildings six, of vessels five.”] According to Rebbi Meןr who says that the Ark was made with a cubit of six hand-breadths, the length of the Ark was fifteen cubits, as it is written: Its length two cubits and a half. Each cubit was six and half a cubit three. Four tablets were in it, two whole ones and two broken ones, as it is written: Which you broke and put into the Ark. Each of the tablets was six hand-breadths in length and three in width. Put the widths of the tablets in the length of the Ark, there were three hand-breadths left. Apply them to the cylinder. [On each side half a hand-breadth to have a handle, and two hand-breadths as place to put there the Torah scroll.] The width of the Ark was nine hand-breadths, as it is written: A cubit and half a cubit. A cubit six and half a cubit three. Four tablets were in it, two whole ones and two broken ones. Each of the tablets was six hand-breadths in length and three in width. Put the lengths of the tablets in the length of the Ark, there were three hand-breadths left. On each side half a hand-breadth to have a handle, and two hand-breadths as a place to put there the Torah scroll.
HALAKHAH: For the roof three, for the balustrade ten {hand-widths}.
Does one have to sever the trim? Rebbi Jeremiah, Rebbi Ḥiyya in the name of Rebbi Simeon ben Laqish: David grasped. There is no grasping less than a hand-breadth. And tore them, Rebbi Simon in the name of Rebbi Joshua ben Levi: From here that he has to sever the trim. If a relative died, he rends. If another relative died, even if he heard about his father or his mother, or his teacher who taught him wisdom, he rends one tear for all of them. Rebbi Jehudah ben Tema says, he rends for each one separately, only that he shall not make that for his father or his mother as an addition. Is that not the first {statement}? But he may not add to that for his father or his mother. Rebbi Ḥelbo and Rav Mattana, Yose ben Manisha in the name of Rav: Practice follows Rebbi Jehudah ben Tema. If a relative died, he rends. If another relative died, he adds to the tear and rends. How far? Rebbi Ḥanina said, until he reaches to his navel. An old man stated before Rebbi Ze`ira: Even if he receives another garment during all the Seven he is obligated to rend. Rebbi Ze`ira said to him, this you are saying about other relatives. But for his father and his mother even after the Seven he is required to rend. If a relative died, he rends. If another relative died, he moves three finger-widths and rends. If the front is full he starts in the back. If the upper part is full he starts with the bottom part. If both of them are full, Rebbi Ḥiyya the son of Rebbi Ada from Yafo says, he became shabby.
Rebbi Joḥanan said, the Ark was made with a cubit of six handbreadths. Who stated “a cubit of six handbreadths”? This is Rebbi Meïr. As we have stated: “Rebbi Meïr says, all cubits were average.” According to Rebbi Meïr who says that the Ark was made with a a cubit of six handbreadths, the length of the Ark was fifteen cubits, as it is written: “Its length two cubits and a half.” Each cubit was six and half a cubit three. Four tablets were in it, two broken ones and two whole ones, as it is written: “Which you broke and put into the Ark.” Each of the tablets was six handbreadths in length and three in width. If the widths of the tablets were in the length of the Ark, there were three handbreadths left. Apply them to the cylinder. The width of the Ark was nine handbreadths, as it is written: “A cubit and half a cubit.” A cubit six and half a cubit three. Four tablets were in it, two broken ones and two whole ones. Each of the tablets was six handbreadths in length and three in width. If the lengths of the tablets were in the length of the Ark, there were three handbreadths left. On each side half a handbreadth to have a handle, and two handbreadths as place to put there the Torah scroll.
Rebbi Simeon ben Laqish said, the Ark was made using a cubit of five handbreadths. Who stated “a cubit of five handbreadths”? This is Rebbi Jehudah. As we have stated there: “Rebbi Jehudah says, the builders’ cubit was of six handbreadths, but that of vessels five handbeadths.” And the Ark is a vessel. According to Rebbi Jehudah who says that the Ark was made with a cubit of five handbreadths, the length of the Ark was twelve and one half cubits, as it is written: “Its length two cubits and a half.” Each cubit was five and half a cubit two and one half. Four tablets were in it, two whole ones and two broken ones, as it is written: “Which you broke and put into the Ark.” Each of the tablets was six handbreadths in length and three in width. If the widths of the tablets were in the length of the Ark, there was half a handbreadth left. One finger’s thickness for the wall on either side. The width of the Ark was seven and one half handbreadths, as it is written: “A cubit and half a cubit.” A cubit five and half a cubit two and one half. Four tablets were in it, two whole ones and two broken ones, as it is written: “Which you broke and put into the Ark.”. Each of the tablets was six handbreadths in length and three in width. If the lengths of the tablets were in the width of the Ark, there were one and a half handbreadths left. One finger’s thickness for the wall on either side, and on each side half a handbreadth to have a handle.